Support Center

What if there are multiple blue dots on an appliance or part?

Last Updated: Aug 17, 2015 10:00PM EDT
If the part or appliance shows multiple dots, that gives you the ability to manipulate the size and coverage of that part. For example, when a labial bow is on the Rx canvas on the upper arch, two dots appear on each side on the omega loop. You can click and drag a blue handle on either side and move that part to cover any tooth desired. This gives you the ability to make the 3-3 bow into a 4-4 bow, or a 3-4 bow. Now if you want to move that bow to the lower, just click and drag any blue dot on the bow and drag it over to the lower. This applies to every part that has a blue dot.

Contact Us
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found